|
167 11th
Street,
Dona Rosario Village,Basak
Mandaue City, Cebu 6014
63 32 (344-6538) |
Accountrements
Security Alarm Trading & Services
DATE \@ "MMMM d, yyyy" September 29,
2008
Attn: Site Owners
V Rama Street
Cebu City, Cebu
Re: High Voltage Security Fence
for Catarman, Liloan Plant
Dear Sir/Madam,
We are pleased to offer the following
for your consideration;
1.
An electric fence requires maintenance to maintain
its integrity. The fence has to be cleared of fallen foliage
on a regular basis. We warrant the workmanship of the
installed fence and all electronic components for a period
of one (1) year. This does not provide for operational
failure or damage caused by fallen foliage, fronds, or
branches. We recommend that the fence is to be visually
inspected at least once per week.
2.
We also warrant the effectiveness of the fence by
offering p5,000.00 to any of your people that can
demonstrate that they can get by, or over the fence without
creating an alarm condition. This offer is valid upon
completion of the installation and before final acceptance.
If such a condition can be demonstrated, HWM Safety and
Security reserves the right to modify the installation (at
our expense) to prevent any further such happenings.
Description of Installation:
This will be a six (6) strand system on all sides of your
complex. On the back and across the right side, the fence
will be installed on top of the concrete wall after removal
of the existing old barbed wire. On the front, the system
will go over the entrance gate, then over the guard-house;
continuing across the front the electric fence supports will
then be welded under the air conditioning balcony and around
the corner and then will travel vertically to 50cm under the
roof. On the left side the fence will extend out from the
wall at 45 degrees down 50cm from the roof edge to
completely block any intrusion from that quarter.
 
The insulator supports will be constructed of 12mm form bar
cut to length. The corner and end insulator supports will be
constructed of 16mm form bar cut to length. Each piece of
form bar will be formed and dipped in a quality rust
preventing primer, and dipped again in a quality white
enamel (or color of your choice). The fence wire supporting
insulators between corners and ends will be our part number
ASAT-75, with the corner and end insulators to be our part
number LOC-41. The wire fence strands will be galvanized
steel solid wire. The “charged” strands will be supported
approximately every 2 meters.
We are estimating that the compound is approximately 130
meters by 60 meters and calculating the number of components
accordingly. If the number of insulators, etc. is less than
the number calculated, then the price will be adjusted
accordingly.
1 10,000 volt fence charger
p 15,032.00
1 fence voltage and maintenance monitor
p 15,975.00
80 pieces 12mm form bar
p 20,000.00
20 pieces 16mm form bar
p 7,000.00
1,200 pieces insulators (part no
ASAT-75)
p 43,200.00
120 pieces insulators (part no
LOC-41)
p 840.00
4 pieces 8 foot ground rods with
clamps
p 3,960.00
72 pieces wire stretchers (part no
ASAT-17)
p 38,721.60
180 kilos of 16 AWG galvanized steel wire
p 10,800.00
40 pieces warning signs (part no
ASAT-54)
p 7,200.00
2 pieces 12 volt
battery
p 1,400.00
2 pieces 12 volt battery chargers
p 900.00
Misc components; screws, connectors, hookup wire, through
wall insulation
welded components, crimp
connectors
p 16,000.00
50 man-days labor (preparation and
installation)
p 30,000.00
___________
sub-total
p211,028.60
VAT @
12%
p 25,323.40
___________
Total
Cost (prices may vary after 15 days past date of this
proposal)
p236,352.00
TERMS: (Standard) 10%
deposit with order; 60% required when materials are
delivered on site; The final 30% is due upon completion and
acceptance.
Sincerely Yours,
Chief Engineer
|
